Your child spills his juice all over the carpet. You reason, “I’ll get that later,” so it’s all right. A forkful of spaghetti sauce falls from your plate onto the carpet in your living room two days later as you’re eating in front of the TV. Unfortunately, you won’t be leaving your dinner to be cleaned. Before you realize it, your carpet has a strange odor, is covered with stains, and is in desperate need of a deep clean. But can you properly clean a carpet? Even if you succeed, it won’t be as effective as this manual! For the best carpet cleaning techniques, keep reading.
4 Steps to Deep Cleaning a Carpet
Deep carpet cleaning is a difficult task. It drains you considerably, therefore it would be wise to set yourself free for the day. It will feel like the most satisfying experience ever once you’re done. the following steps:
Remove all dirt and dust by vacuuming
If you start cleaning straight away, it will be like digging the dust and grime deeper into the carpet, where it will irritate forever. Vacuuming always comes first because of this.
First, rearrange the furniture so that nothing blocks the carpet.
Once the vacuum is turned on, repeatedly clean the carpet until it is spotless. It will be covered in stains, pet dander, and dirt from the bottom of your shoes.
To reach the difficult-to-reach spots in corners, use the vacuum’s attachments. You can put the extensions below any furniture that is particularly difficult to move.
Treat the Stains
The most challenging component of cleaning your carpet right now is eradicating the stains. Vacuuming is simple, and what follows is much simpler. Though stains? The actual difficulty lies in these. You can clean the stains in a variety of ways, depending on their type and severity. Here is a summary.
Employ carpet shampoo.
Using carpet shampoo to clean your carpet seems like the most logical choice. However, it necessitates that you purchase it first. Using vinegar or baking soda that you already have in your pantry seems much simpler for some reason. However, shampoo will clean more thoroughly and give a pleasant after-cleaning smell.
First, look for mixing instructions on the container. Some shampoos can be used right away, while others need to be diluted with water first.
Apply the shampoo to the carpet after that without applying too much. Due to the lengthy drying period of shampoo, the rug shouldn’t be very wet.
With a brush, begin working the shampoo into the carpet. An old cloth can be used to blot small, difficult spots.
After letting the shampoo dry for a few hours, vacuum it up. Using a cloth, you can also get rid of the extra pieces beforehand.
Employ distilled vinegar.
Although vinegar is less expensive than carpet shampoo, it is only effective on carpets that are only moderately unclean and free of tenacious stains. It’s important to note that it occasionally could result in discoloration, so you should test it on a tiny quantity first. Distilled vinegar can be used by combining it with water in a spray container. The appropriate ratio is 1:1:3. If your carpet is huge, use a large spray bottle so you won’t have to keep refilling it. Additionally, you might want to install a barrier to protect the floor if your carpet doesn’t have a waterproof bottom.
Spray the vinegar liberally throughout the entire carpet. You only need to wait for the solution to soak into the rug for a few minutes; there is no need to scrub. After that, take a microfiber towel and begin blotting it. When the vinegar isn’t soaking the carpet, dip it in water, wring it out thoroughly, and then blot once more. Leave the carpet to air-dry for a few hours after you’re finished.
If you need carpet cleaning and you don’t want to do it yourself, give us a call today. For Fast Service, Call (864) 905-8566
